Philips PR3733 Mode D'emploi page 14

ENGLISH
14
Starting and stopping treatment
The BlueTouch Pain Relief Patch has three modes and an 'off ' setting
(see chapter ' Treatment schedule and treatment modes'). Press the mode
button one or more times to select one of the three treatment modes.
When you press the mode button a fourth time, you switch off the
BlueTouch Pain Relief Patch.
1 Mode 1 (low): press once
2 Mode 2 (medium): press twice
3 Mode 3 (high): press three times
4 O (off): press four times
Note: If you want to switch from mode 3 to mode 1 or 2 or from mode 2
to mode 1, you have to press the mode button as many times as required to
reach the mode you want to select.
In mode 1 (low), four rows of LEDs light up in power-save mode.
,
The BlueTouch Pain Relief Patch beeps once.
Note: After 10 seconds the light intensity slowly increases from power-save
mode to the intensity of the mode selected. Put the BlueTouch Pain Relief Patch
on the treatment area within these 10 seconds.
In mode 2 (medium), six rows of LEDs light up in power-save mode.
,
The BlueTouch Pain Relief Patch beeps twice.
In mode 3 (high), all LEDs light up in power-save mode.
,
The BlueTouch Pain Relief Patch beeps three times.
When the light intensity starts to increase, you hear a dual tone from
,
low to high.
The BlueTouch Pain Relief Patch automatically switches off after the
,
treatment time of the selected mode has elapsed. You hear a triple
tone from high to low to indicate that the device has switched off.
Note: If you want to switch to another mode during treatment, for instance
because you experience the current intensity as unpleasant, press the mode
button one or more times to select another mode. The timer automatically
recalculates the remaining treatment time based on the new mode.
Note: If you want to switch off the device before the treatment time has
elapsed, press the mode button one or more times until the LEDs switch off
and you hear a triple tone from high to low.