Hahnel MODUS 360RT Manuel D'instructions page 14

• < > FEC: Flash Exposure Compensation
With FEC function, this flash can adjust from -3 to +3 in 1/3rd stops.
It is useful in situations where minor adjusting of the TTL system is
needed based on the environment.
< > High-Speed Sync
On the camera Flash Function Setting Menu set <SYNC> to Auto FP
< HSS > The HSS Icon <
display.
< >
Second-Curtain Sync (Rear-Curtain Sync)
On the camera Flash Function Setting Menu set <SYNC> to Second
Curtain.
The Second Curtain sync icon <
360RT display.
To Revert to normal first curtain sync, select first curtain in the
<SYNC> section of the Flash Function settings menu.
• With high-speed sync, the faster the shutter speed, the shorter the
effective range.
• Try to avoid using high-speed sync flash, to extend the flash tube's
lifetime.
• Over-temperature protection may be activated after 15 consecutive
high-speed flashes.
• MULTI Flash mode cannot be set in high-speed sync mode.
• LCD will display "Hi" (blinking for 3 sec.) when flash output is up
to maximum value. If the photo is underexposed, adjust camera
parameters accordingly.
• LCD will display "Lo" (blinking for 3 sec.) when flash output is
at minimum value. If the photo is overexposed, adjust camera
parameters accordingly.
Setting FEC:
1 Press the <SET> Button and the
flash exposure compensation
amount will be highlighted on the
LCD panel
2 Turn the Select Dial to set the
amount.
● "0.3"means 1/3 step, "0.7"means
2/3 step.
● To cancel the flash exposure
compensation, set the amount
to "0".
3 Press < SET > button again to
confirm the setting.
> -is switched ON on the Modus 360RT
> is activated ON on the Modus
14