Operation; Functions And Analogue Display - Renkforce MD 150 Notice D'emploi

Material Electrical
conductivity (S/m)
Silver 63.01 × 10
Nickel 14.3 × 10
6
Copper 59.6 × 10
6
Iron 9.93 × 10
6

11. Operation

a) Functions and analogue display
Push button (reset) (8)
Dials DISCRIMINATION (7)
TUNE dial (11)
VOLUME dial (6)
Analogue display (5)
(with battery level indicator)
Loudspeaker
Headphone jack (10)
Battery test switch (9)
Material
Gold
6
Platinum
Aluminium
Tin
Together with the TUNE dial (11), this push button is designed to set/adjust the
zero position of the display pointer.
Use this dial to configure the discrimination threshold for different metals.
The TUNE dial (11) is designed to tune the detection probe (1) to the electronic
components in the control unit (13). It corrects the zero position on the analogue
display (5).
This dial is used to set the volume of the audible signal. This applies equally for
loudspeakers and headphones.
Displays the approximate material type (right = non-ferrous metal, left = ferrous
metal)
When the battery voltage is low (<6.5 V/DC), the pointer does not point to the
green area.
Audible signals
Connect suitable headphones to the 3.5 mm jack. The in-built loudspeaker is
switched off.
Use this switch to select the operating mode and battery test mode.
Electrical
conductivity (S/m)
45.2 × 10
6
9.66 × 10
6
37.8 × 10
6
9.17 × 10
6
Material Electrical conductivity
(S/m)
Calcium 29.8 × 10
Zinc 16.6 × 10
Cobalt 16.7 × 10
Salt water 4.788
Fresh water 0.0005 - 0.05
6
6
6
29