Elem Garden Technic FBHT65-22TCH Traduction Des Instructions D'origine page 79

Step 9: Attach Hydraulic Hoses and Cradle
1. Thread the outlet connector (#59) to the top of the gear pump (#47). Use Teflon tape to
ensure tight fit.
2. Place an O ring (#61) onto the exposed threads of the outlet connector. Then attach
hose (#13) to outlet connector.
3. Attach hose (#15) to the port on the oil tank. Place an O ring (#61) on the port and
tighten the hose using Teflon tape.
4. Attach the oil pipe (#60) to the bottom of the gear pump (#47) by the clamp (#78).
5. Attach the cradle (#107) to the beam (#1) by using hex bolt M8x25 (#44) and nylon
lock nut M8 (#57).
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-sales service department.
AFTER-SALES SERVICE AND APPLICATION SERVICE
Our after-sales service responds to your questions concerning maintenance and repair of
your product as well as spare parts. Exploded views and information on spare parts can also
be found under:www.eco-repa.com
ELEM GARDEN TECHNIC application service team will gladly answer questions concerning
our products and their accessories : sav@eco-repa.com
79