Télécharger Imprimer la page

Husqvarna K 1270 Rail Manuel D'utilisation page 29

Masquer les pouces Voir aussi pour K 1270 Rail:

Publicité

Les langues disponibles

Les langues disponibles

Fitting the starter
To fit the starter, first pull out the starter cord and place
the starter in position against the crankcase. Then
slowly release the starter cord so that the pulley
engages with the pawls.
Tighten the screws.
Fuel system
General
Check that the fuel cap and its seal are not damaged.
Check the fuel hose. Replace when damaged.
Fuel filter
The fuel filter sits inside the fuel tank.
The fuel tank must be protected from contamination
when filling. This reduces the risk of operating
disturbances caused by blockage of the fuel filter
located inside the tank.
The filter cannot be cleaned but must be replaced with
a new filter when it is clogged. The filter should be
changed at least once per year.
Air filter
The air filter only needs to be checked if the engine drops
in power.
Loosen the screws. Remove the air filter cover.
Check the air filter and replace if necessary.
All manuals and user guides at all-guides.com
MAINTENANCE
Replacing the air filter
NOTICE! The air filter must not be cleaned or blown
clean with compressed air. This will damage the filter.
Loosen the screw.
Replace the air filter.
Drive gear, clutch
Check the clutch centre, drive gear and clutch spring
for wear.
English
29

Publicité

loading

Ce manuel est également adapté pour:

K 1270