Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Alarm No.
-
Auto-stop with fas-
tening completion
-
Alarm for insufficient
fastening
-
Alarm for limit of the
fastening capacity
-
Maintenance alarm
-
Alarm for no com-
munication with
the PC
-
Indication that the
tool can communi-
cate with the PC
-
Check for the lamp
and beeper (when
the battery cartridge
is installed)
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Selecting correct impact socket
Always use the correct size impact socket for bolts and
nuts. An incorrect size impact socket will result in inac-
curate and inconsistent fastening torque and/or damage
to the bolt or nut.
Function
Status of the tool
The preset fasten-
ing torque has been
achieved and the
tool has stopped.
The preset fas-
tening torque has
not been achieved
because the switch
trigger was released
before completing
the fastening.
The number of drive
has been reached to
your preset number
for the maintenance.
No data commu-
nication while the
tool is connected to
the PC.
The tool is con-
nected to the PC
and able to commu-
nicate with.
The tool performs
the operation test
for the LED indicator
(green/red), light,
and beeper.
Status of the LED indicator/beeper
LED indicator
Lights up in green
for approximately
one second.
Lights up in red for
approximately one
second.
Blinks in red quickly.
Blinks in yellow.
Blinks in yellow.
Blinks in green.
The LED indicator
lights up in green
and then red. After
that, the light turns
on for a while.
Installing or removing impact socket

Optional accessory

CAUTION:
Make sure that the impact socket
and the mounting portion are not damaged before
installing the impact socket.
CAUTION:
After inserting the impact socket,
make sure that it is firmly secured. If it comes out,
do not use it.
1
2
► 1. Impact socket 2. Square drive
To install the impact socket, push it onto the square
drive of the tool until it locks into place.
To remove the impact socket, simply pull it off.
12 ENGLISH
Action to be taken
Beeper
A long beep
Retighten the
fastener.
A series of long
Replace the battery
beeps
with fully charged
one.
Reset the alarm
with the application
software.
Restart the appli-
cation software and
re-connect the USB
cable.
A series of very
short beeps

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dtwa100Dtwa140Dtwa190

Table des Matières