SOUNDMASTER IR3500SW Mode D'emploi page 24

3. Setup wizard
Select the "YES" option to continue with the setup. If you select the "NO" option, the next
display asks you whether the setup wizard should be started the next time the device is
switched on.
4. Time/Date Display format
Select 12 or 24 as the time format.
5. Auto update
The time and date can be updated manually or automatically from DAB, FM or network.
Auto update works with data sent over DAB, FM or the Internet. The clock is only updated
when it is in a corresponding mode, so it is suggested to select a mode you use regularly.
DAB and FM use time signals broadcast with radio transmissions. Network uses a time
signal sent from the Internet radio portal when in any network connected mode.
6. Time zone/daylight
Set your time zone. If your country uses daylight saving and it is in effect, turn on the
Daylight saving option. (only available when Auto update from Internet is selected)
Manual update
If you set No update, the wizard prompts you to set the time and date manually. The date
and time are displayed as dd-mm-yyyy and hh:mm.
The active value appears as flashing. Adjust each value with the "NAVIGATE" knob. Once
the value is set, press the knob to continue setting with next value.
7. Network
Keep Network connected
Select this option when the unit should the network connection in standby keep, when the
function is confirmed, the unit wills faster connecting the internet and it is possible to switch
on the unit with the "UNDOK" app. The standby power consumption is slightly increased
with this function.
WLAN region
Select the WLAN region to obtain the optimal WLAN connectivity: Europe.
Scanning for the network
IR3500 is compatible with all common network protocols and encryption methods. It
searches for the available networks and list them out for you. If the device is connected to
the network with a LAN cable, select the item "Cable" in the selection.
For the wireless connection, you will be asked for input the
encryption in the next step (WiFi only!). To enter the network's key,
use the "NAVIGATE" knob to move the cursor through the
characters and press "OK" to confirm. As each character is
selected, the key is built up near the top of the display.
There are three options accessible by tuning the navigate reel back
before the first characters – Backspace, OK and Cancel.
WPS encrypted network
WPS encrypted networks are identified by WPS at the start of the network name when the
IR3500 / English Instruction Manual
5