Makita EM2652LHN Manuel D'instructions page 14

CORRECT HANDLING OF MACHINE
Attachment of shoulder strap
– Adjust the strap length so that the cutter blade will be
kept parallel with the ground.
For EM2650UH
NOTE: Be careful not to trap clothing, etc., in the buckle.
Detachment
For EM2650LH, EM2652LHN (Optional accessory)
– In an emergency, push the notches (1) at both sides, and you can detach the
machine from you.
Be extremely careful to maintain control of the machine at this time. Do not
allow the machine to be deflected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could
result in serious bodily injury or DEATH.
For EM2650UH
– In case of emergency, remove the emergency detachment lever (2) by pulling
strongly with a finger. The machine sill detach from body.
Be extremely careful to maintain control of the machine at this time. Do not
allow the machine to be deflected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could
result in serious bodily injury or DEATH.
POINTS IN OPERATION AND HOW TO STOP
Observe the applicable accident prevention regulations!
STARTING
Move at least 3 m away from the place of refueling. Place the unit on the ground taking care that the cutting tool does not come into contact with
the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to OPERATION.
Lock-off lever
OPERATION
STOP
High speed
Low speed
Throttle lever
(1)
14
(1)
Hanger
(2)
Hanger
STOP
Throttle lever
Low speed
High speed
EM2650LH
EM2652LHN
Buckle
EM2650UH
(1)
OPERATION
Lock-off lever
EM2650UH