Work Area - DUROFIX RZ6008 Série Mode D'emploi

1English1
Be sure to understand them well before using the product.
WARNING
Put on a safety helmet, safety boots, anti-vibration gloves, face protector
(safety glasses and mask) and safety belt before using the vibrator.
If the work place is hard to stand on, such as reinforcing steel, lay a plate
on it to gain the scaffold for walking.
If the machine stops suddenly, turn off the switch and remove the battery.
Otherwise, the motor may burn or electric shock may occur.
When using the vibrator near feet or in places that are not very deep,
concrete may be splattered around. Use a face protector (e.g. safety glasses
and mask) to protect your eyes and mouth.

WORK AREA

CAUTION
The power switch should be turned ON/OFF only
when the head assembly is not inserted in the
ready-mixed concrete.
If the power is turned OFF,
while it is the vibrator is inserted in the ready-
mixed concrete, it may not be able to remove the
head assembly.
Forcibly pulling it out may cause injury.
Do not pry or twist the vibrator with a small force
among the reinforcing bars or the mold form with
the head assembly. Otherwise the vibration unit
may become abraded.
Do not place heavy objects on the product.
The head assembly of this product should not be operated on hard surfaces such
as concrete or steel plate. Bearings and shafts might be damaged.
Do not attach or detach the battery while the switch is turned on.
English -4