DUROFIX RZ6008 Série Mode D'emploi page 15

After use, should be cleaned very well
1. Remove the battery from the motor assembly for cleaning and transportation.
2. The concrete attached to the vibrator should be removed before it hardens.
3. Remove the dust and concrete on the motor assembly.
4. For transportation, hold the motor assembly or the vibrator assembly and carry the
vibrator.
5. Do not wash the motor assembly with water.
(Wipe the motor assembly with a dry damp cloth or a cloth moistened with
detergent.)
Before carrying the vibrator to the fields and also after use, be sure to check the
followings.
It prevents any trouble as much as possible during use.
1.
Are there any wear, cracks or damage on the head assembly?
2.
Looseness of the fix bolt on the vibration portion? (C25DS, 28DL,KCA)
3.
Are there any wear, damage or scratches on the flexible hose? (C28FPL)
4. Is there any dirt or rust on the terminals?
5. Can the switch be turn ON and OFF properly?
6. Is the vibrator operation sound normal during operation?
(It is normal if there is regular and continuous sound.)
7. Switch lock function (Lock/Release)
REPLACEMENT PERIOD FOR THE CONSUMABLES
Consumables should be replaced periodically according to the below table.
Consumables
Head housing
Lubricating oil
Bearing
Motor
Flexible hose
Flexible shaft
1English1
Replacement period by sight and hearing
Determine depending on the wear (visual)
Determine from noise during operation
(audible)
Determine from noise during operation
(audible)
Rotation stops (audible/visual)
Determine depending on the wear or
scratches (visual)
Determine depending on the wear (visual)
English -14
Replacement period
(Target: hours)
300‐500
100‐200
100‐300
Upon found
Upon found
Upon found