DUROFIX RZ6008 Série Mode D'emploi page 12

REMOVING AND INSTALLING BATTERY PACK
Be sure to take your hand off the switch when attaching or detaching the battery.
■ Removing
1. Remove the clip of the battery cover, and then open the battery cover.
2. Press both Release buttons on both sides of the battery pack and remove it.
■ Installing
1. Put a battery pack on the charger align rails on motor assembly and battery holder.
Slide the battery back forward onto the charger until it stops.
2. Close the battery cover before use.
If the battery cover contacts the battery and does not close, put the battery back
into the place again and try to close the battery cover.
Battery cover
CONNECTING THE HARD SHAFT AND FLEXIBLE SHAFT AND BLOCK
When connecting the motor and the vibrator assembly, turn off the switch and
remove the battery from the motor assembly.
■ C25DS / 28DL
1. Screw the spring assembly onto the motor.
2. Insert the spring assembly (female) and the vibrator assembly (male), and
then, secure the vibrator assembly with 4-M5 bolts.
1English1
ASSEMBLY
Battery
Clip
English -11
Press
Remove