Troubleshooting - Danby Designer DWC310BLSDD Guide D'utilisation Et Soins De Propriètaire

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this trou-
bleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or
Danby's Toll Free Number 1-800-263-2629 for assistance.
PROBLEM
1) No power.
2) Cabinet temperature too
high.
3) Condensation on the
cabinet and/or doors.

TROUBLESHOOTING

POSSIBLE CAUSE
• A fuse in your home may be
blown or a circuit breaker
tripped
• Power surge
• Plug is not fully insterted into
wall outlet.
• Temperature Setting.
• Door not shut properly or
opened excessively.
• Interior lights toggled on.
• Exhaust vent is obstructed.
• Recently added large quantity of
warm bottles to cabinet.
• High humidity conditions in the
home.
9
SOLUTION
• Replace fuse or reset circuit
breaker.
• Unplug the wine cooler, wait a
few seconds and plug back in.
• Make sure the 3-prong plug is
fully inserted into outlet.
• Verify the temperature control
setting; adjust if necessary.
• Ensure door is fully closed and
the gasket is sealing against the
cabinets. Open door only as
needed and for short periods of
time.
• The interior lights are intended
for temporary lighting of
cabinets for display purposes
only.
• Verify that nothing is blocking
front-mounted exhaust vent.
• Limit quantity of warm bottles
introducted at the same time.
Stagger the load introduction if
possible.
• Ensure door is fully closed and
gasket is sealing against the
cabinet. Open the door only as
needed and for short periods of
time.