Information codes
If the washer fails to operate, you may see an information code on the screen. Check the table below and try
the suggestions.
Code
Clean drain filter
Check water supply
faucets and restart
Please connect the
hot/cold water hose
connection correctly
Redistribute unbalanced
load and restart
Close the washer door
and try again
A2-WW6900_WASHER-MD_SimpleUX_03645H-00_EN.indd 59
Water is not draining.
• Make sure the drain hose is not frozen or clogged.
• Make sure the drain hose is positioned correctly, depending on the
connection type.
• Clean the pump filter as it may be clogged.
• Make sure the drain hose is straightened all the way to the drain system.
• If the information code remains, contact a customer service centre
Water is not supplied.
• Make sure the water taps are open.
• Make sure the water hoses are not clogged.
• Make sure the water taps are not frozen.
• Make sure the washer is operating with sufficient water pressure.
• Make sure that the cold water tap and the hot water tap are properly
connected.
• Clean the mesh filter as it may be clogged.
• All buttons will be disabled for 3 minutes after the information code
appears.
• When the "Check water supply faucets and restart" message appears, the
machine drains water for 3 minutes. In the meantime, the Power button
will be disabled.
• Make sure the cold water supply hose is firmly connected to the cold water
tap. If it is connected to the hot water tap, the laundry may be deformed
with some cycles.
Spinning does not work.
• Make sure laundry is spread out evenly.
• Make sure the washer is on a flat, stable surface.
• Redistribute the load. If only one item of clothing needs washing, such as
a bathrobe or pair of jeans, the final spin result might be unsatisfactory,
and an "Redistribute unbalanced load and restart" check message will be
shown in the display.
Operating the washer with the door open.
• Make sure the door is properly closed.
• Make sure laundry is not caught in the door.
Action
English 59
2022/6/9 9:48:54