Publicité
Les langues disponibles
Les langues disponibles
Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset). Make sure the safety system get in touch with the floor, otherwise the
appliance doesn't work.
Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp
edges, is not wound around the utensil, is not twisted up on itself or in the way to prevent the
utensil from being pulled over. Check that you cannot trip over to prevent accidental falls or harm
to persons.
All repairs should be made by a competent qualified electrician. In any case you should return the
appliance to this service.
DESCRIPTION OF THE APPLIANCE
Frontal part:
Switch for swinging
Lower candle switch
Upper candle switch
Switch 0-I central
candle
1. Protection grill
2. Support
ASSEMBLING
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
ATTENTION: The heater must not be used if the plugs are damaged glass.
Attention: The appliance may only be used if complete with the support.
Inferior part:
3. Wing nut screws
4. Anti-upsetting system
5. Cable slideway
6. Cable
13
Publicité
