Brother P-Touch 2480 Mode D'emploi page 26

Entering bar code data
Press c.
1
2
Type in the new bar code data or edit the old data.
Press n to add the bar code to the text.
3
☞ To add special characters to the bar code data (only with protocols CODE39,
CODABAR, EAN128 or CODE128), position the cursor below the character
immediately to the right of where you wish to add the special character, and then
press s. Press u or d until the desired special character is displayed, and then
press n to add the character to the data. (Refer to the tables below for a list of the
special characters that are available.)
☞ To change the data or WIDTH or UNDER# parameter settings of a bar code that has
already been added to the text, position the cursor below the bar code mark (
g
then press
The following special characters can only be added to bar codes created using protocol
CODE39 or CODABAR.
CODE39
Symbol Character
–
0
1 .
2 (SPACE)
3 $
c
, then .
Symbol Character
4 /
5 +
6 %
CODABAR
Symbol Character
–
0
1 $
2 :
), and
Symbol Character
3 /
4 .
5 +
19