LOVENS EXPLORER Manuel De L'utilisateur page 12

7. Close the loop connectors with the
caps.
EN
Figure 7 - Closing loop connectors.
WARNING
• If you do not use the rain cover, it is
important to remove the adapters from
the frame. This ensures that children's
fingers cannot get trapped in the
adapter.
8. Take the fabric with the rod assemblies
and place this in the Lovens Explorer
adapters.
Figure 8 - Attaching the rods.
9. Attach the press connectors on the
front of the bike to the fixing points in
the front side.
Figure 9 - Attaching press connectors front side.
12
PLEASE NOTE
❾
• Ensure that the press connectors on
the front are properly closed. If the
press connectors are not attached or
closed properly, hazardous situations
may arise.
Figure 10 - Correct position press connectors.
10. Attach the rubber band at the rear to
the loop connector to close the rain
cover.
Figure 11 - Attaching the loop to the loop connectors.