Rupes 9HP120LT Manuel D'instructions page 5

Disposing of Rupes Power Supply 9HP120LT
Always dispose of your Power supply according to federal, state and local regulations. Contact a recycling agency
in your area for recycling locations
DISPOSAL (WEEE DIRECTIVE)
For EU countries only: According to the European Directive on Waste from electrical and electronic equipment
and its implementation in conformity with national standards, exhausted electrical equipment must be collected
separately, in order to be recycled in an environmentally friendly way. The product, when it reaches the end of
its life, must not be dispersed in the environment or thrown away as household waste. It must be disposed at
authorized recycling centres (contact your local authorities to know where to dispose of the product according to
the law). The correct disposal of the product contributes to the health and preservation of the environment. Illegal
disposal of the product will entail penalties against the offenders.
RUPES BIGFOOT iBrid NANO tool Part Numbers:
HR81M
HR81ML
9HC120LT
9HB120LT/9HB125LT – Li-Ion Battery pack
9HP120LT
FCC Compliance Statement
IMPORTANT NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide a reasonable protection against
harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interfrence in which case the user will
be required to correct the interference at his own expense.
NOTICE: Changes or modifi cations not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
WARRANTY
Complying with current applicable regulations and subject to more favorable conditions that could apply in diffe-
rent countries, RUPES professional tools are supplied with a 12 months warranty against manufacturing defects
from date of purchase. Only Rupes original parts and accessories must be employed with RUPES tools. Rupes is
not responsible for any damages or accidents caused by not abiding to this rule and the warranty shall terminate
if non-original parts are employed. Damages caused by natural wear and tear, overloading, faulty maintenance
and tool usage differing from the one specified in the user guide, are not covered by this warranty. A tool which
has been proven faulty must be delivered to an authorized Rupes service center along with its fully filled out war-
ranty certification and document of purchase. Warranty shall be void if tool should be delivered disassembled or
tampered. This warranty does not in any way imply tool's replacement. RUPES S.p.A. reserves the right to make
specifications or design changes to its products without further notice. RUPES does not accept any responsibility
for any possible printing mistake. This document supersedes all previously printed one.
FREE LABEL REPLACEMENT: If your labels become illegible or are missing, call 0039 02 94 694 1 RUPES
S.p.A. for a free replacement.
– Short neck RUPES BIGFOOT iBrid NANO tool
– Long neck RUPES BIGFOOT iBrid NANO tool
– Li-Ion Battery Charger
– Power Supply for RUPES BIGFOOT iBrid NANO tool
5