Parkside PSZ 250 A2 Instructions D'utilisation Et Consignes De Sécurité page 20

˜ Lifting loads
Lower the steel cable
comfortably .
Fasten the load to the hook
additional bungee cords where necessary .
The load's centre of gravity must be beneath
the product .
Wind up the steel cable
Then fully lift the load .
˜ Maximum/minimum length
levers
NOTE
The maximum/minimum length
u
levers are not intended to regularly
15 ] [ 16 ] [
stop the product . Always attempt to stop
the product before it triggers one of these
levers .
Minimum cable length lever
When the steel cable
14 ] [
minimum cable length lever
The steel cable cannot be wound up any further . It
can only be unwound .
Maximum cable length lever
When the steel cable
[ 14 ]
maximum cable length lever
The steel cable cannot be unwound any further . It
can only be wound up .
˜ Emergency off switch
(Fig . J)
In case of an emergency, press the
emergency off switch
lowering operation .
The product is then locked . To unlock the
product, turn the emergency off switch
slightly clockwise (in the direction of the
arrow) until it pops out .
20 GB/IE
so you can handle it
14 ] [
. Use
10 ] [ [ 12 ]
until it is only taut .
14 ] [
is fully wound up, the
will be triggered .
[ 15 ]
is fully unwound, the
will be triggered .
[ 16 ]
to stop lifting or
[ 7 ]
7 ] [
˜ Set-up as block and tackle
Accessories
The following tools are needed for the safe and
proper use of the block and tackle function:
2 spanners (8 mm)
2 spanners (13 mm)
m WARNING
Do not use any accessories not
u
recommended by Parkside .
Setting up the product as a block and tackle
distributes the load to 2 pulleys . This allows twice
the weight to be lifted . However, the maximum
lifting height and speed are reduced by half .
Fasten the hook
12 ] [
opening . The steel cable
18 ] [
loop (Fig . C) .
Dismantle the pulley
Remove the 3 screws (Fig . F) .
Hang the pulley
[ 11 ]
steel cable (Fig . G) .
[ 14 ]
Attach the screws and the extra hook
the pulley . Fasten the 3 screws (Fig . H) .
[ 11 ]
The block and tackle is now operational
(Fig . I) .
˜ Cleaning and care
m WARNING!
Disconnect the device from the power supply
before inspections, maintenance or cleaning!
˜ Cleaning
Ensure that no water enters the product
interior .
Regular, proper cleaning helps ensure safe
operation and lengthens the service life of
your product .
Clean the product with a dry cloth . Use a soft
brush for hard-to-reach areas .
to the intended mounting
now forms a
14 ] [
of the extra hook:
11 ] [
in the loop formed by the
to
10 ] [