Insignia NS-OTR16SS9 Mode D'emploi page 15

NS-OTR16SS9 REV B_20-0410_MAN_V1_EN.fm Page 15 Thursday, December 10, 2020 9:36 AM
5 Carefully push the louver back into place and replace the louver mounting screws.
Changing the light bulbs
Countertop light (exterior)
1 Disconnect power to the microwave at the circuit breaker or by unplugging it.
2 Remove the screw holding the light cover in place, then remove the light cover.
•
3 Remove the old light bulb, then replace with a new bulb.
•
4 Replace the light cover and secure it with the screw.
Light cover
Microwave light (interior)
1 Disconnect power to the microwave at the circuit breaker or by unplugging it.
2 Remove the louver mounting screws from the top center of the louver, then push down on the tabs at each end
of the louver to disengage it.
CAUTION
The light cover may become very hot. Do not touch the glass when the light is on.
CAUTION
Do not use a bulb larger than 30 watts.
BOTTOM
Screw
Louver mounting screws
www.insigniaproducts.com
1.6 Cu. Ft. Over-the-Range Microwave
Louver
Light bulbs
15