Télécharger Imprimer la page

Insignia NS-OTR16SS9 Mode D'emploi page 13

Masquer les pouces Voir aussi pour NS-OTR16SS9:

Publicité

Les langues disponibles

Les langues disponibles

NS-OTR16SS9 REV B_20-0410_MAN_V1_EN.fm Page 13 Thursday, December 10, 2020 9:36 AM
Cleaning and maintaining your microwave
Cleaning the outside of your microwave
Exterior
The outside surface is precoated steel and plastic. Clean the outside with mild soap and water, then rinse and dry
with a soft cloth. Do not use any type of household or abrasive cleaner.
Door
Wipe the window on both sides with a damp cloth to remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a damp cloth. Avoid the use of spray and other harsh cleaners as they may stain,
streak, or dull the door surface.
Control panel
If the control panel is dirty, open the microwave door before cleaning. Wipe the panel with a cloth dampened
slightly with water only. Dry with a soft cloth. Do not scrub or use any sort of chemical cleaners. Close the door and
press Stop to clear any buttons you may have pressed.
Cleaning the inside of your microwave
Interior
Wipe with a soft cloth and warm water. Do not use abrasive or harsh cleaners or scouring pads. For baked-on food,
use baking soda or a mild soap, then rinse thoroughly with hot water.
Waveguide cover
The waveguide cover is located on the ceiling inside the microwave cavity. It is made from mica so requires special
care. Keep the waveguide cover clean to assure good microwave performance. Carefully wipe with a damp cloth any
food spatters from the surface of the cover immediately after they occur. Built-up splashes may overheat and cause
smoke or possibly catch fire. DO NOT REMOVE THE WAVEGUIDE COVER.
Removing odors
Occasionally, a cooking odor may remain in the microwave. To remove, combine one cup water, grated peel and
juice of one lemon, and several whole cloves in a two-cup glass measuring cup. Boil for several minutes using 100%
power, then let it cool in the microwave. Wipe the interior with a soft cloth.
Turntable and turntable support
Remove the turntable and turntable support and wash them in mild, sudsy water. For stubborn stains, use a mild
cleanser and non-abrasive scouring sponge. You can also wash them in the top rack of a dishwasher.
The turntable motor shaft is not sealed, so excess water or spills should be wiped up immediately.
Cleaning and replacing the filters
Cleaning the grease filters
Clean the filters at least once a month. Never use the fan or microwave without the filters in place.
1 Pull down slightly on the tab toward the front of the microwave to remove the filter. Repeat for the other filter.
2 Soak the filter in a sink or dish pan filled with hot water and detergent.
3 Agitate and scrub the filter with a brush to remove embedded dirt.
4 Rinse thoroughly and shake dry.
CAUTION
DO NOT use ammonia or other alkali. They will react with the filter material and
darken it.
www.insigniaproducts.com
1.6 Cu. Ft. Over-the-Range Microwave
13

Publicité

loading