Insignia NS-OTR16SS9 Mode D'emploi page 14

NS-OTR16SS9 REV B_20-0410_MAN_V1_EN.fm Page 14 Thursday, December 10, 2020 9:36 AM
NS-OTR16SS9 REV B
5 Replace by fitting the filter back into the opening.
BOTTOM
Grease filters
Replacing the charcoal filter
A charcoal filter is used for nonvented, recirculated installation. The filter should be changed every 6 to 12 months
depending on use.
1 Disconnect power to the microwave at the circuit breaker or by unplugging it.
2 Remove the louver mounting screws from the top center of the louver, then push down on the tabs at each end
of the louver to disengage it.
Louver mounting screws
3 Pull the louver away from the unit.
Louver
4 Replace the charcoal filter. Make sure that the wire mesh is visible from the front.
Charcoal
filter
14
www.insigniaproducts.com