Meec tools 027415 Traduction Des Instructions D'origine page 55

E3 Blocked rotor.
E4 Obstruction sensor not reset.
E5 The mower has been lifted off
the ground.
E6 Rollover sensor has been
triggered.
E7 Tilt sensor has been triggered.
1. Turn off the robot lawn mower.
2. Turn the mower upside down and inspect
for foreign objects that may be preventing the
rotor from turning.
3. Remove any obstacles.
4. Turn the robot lawn mower right side up,
move it to where the grass is short or adjust
the cutting height.
5. Press the power switch. Then press START
and OK.
1. Turn off the robot lawn mower.
2. Move the robot lawn mower to an area
where there are no obstacles.
3. Remove the floating cover and check that
its cylindrical magnets can move freely –
remove any obstructing objects – and replace
the cover.
4. Press the power switch. Then press START
and OK.
1. Turn off the robot lawn mower.
2. Move the robot lawn mower to an area
where there are no obstacles.
3. Press the power switch. Then press START
and OK.
4. If the error code is still displayed, turn off
the mower and turn it upside down. Inspect
for foreign objects that may be preventing the
front wheels axel from moving freely.
5. Remove any obstructions, turn the mower
upright and press the power switch. Then
press START and OK.
Turn the mower upright. Then press START
and OK.
1. Turn off the robot lawn mower.
2. Move the mower to a flat, horizontal
surface.
3. Press the power switch. Then press START
and OK.
EN
55