Crivit POP-UP BEACH SHELTER Notice D'utilisation page 8

1. Take the product (1) out of the
carrying bag (4) and lay it out
flat on the ground.
2. Loosen the rubber band around
the product.
3. The product pops up by itself into
its initial position.
4. Insert the pegs (3) into the loops
around the product and into the
loops at the ends of the guy lines
(2) and drive the pegs firmly into
the ground.
Taking down
Watch the information
video dealing with
folding the product up
by scanning the QR
code with an appropri-
ate device.
1. Remove the pegs (3) from the
ground.
2. Grip the centre points of the lower
loops in one hand (fig. B).
3. Hold the product up on its edge
while holding all the loops in one
hand (fig. C).
4. Press the top of the upper bow
down towards the ground while
holding the lower bow in place
with your foot and turn them
towards the centre (fig. D).
5. Press both newly formed loops
inwards (fig. E).
8 GB/IE/NI
6. Loosen your grip with the hand
that is holding together the four
loops and push all the bows in
together (fig. F).
7. Fasten the rubber band around
the product and store it in the
carrying bag (4) (fig. G).
Storage, cleaning
Allow all parts to dry thoroughly
before you pack the product away
again. This prevents mould, odour,
and discolouring. When not in use,
always store the product clean and
dry at room temperature.
Incorrect storage of the product
brings the risk of mould formation.
Wipe clean with a damp cloth only
and wipe dry afterwards.
IMPORTANT! Never clean the prod-
uct with harsh cleaning agents.
Clean the pegs and store them in
the bag supplied. Do not store them
in the beach shelter itself.
Disposal
Dispose of the article and the pack-
aging materials in accordance with
current local regulations. Packaging
materials such as foil bags are not
suitable to be given to children.
Keep the packaging materials out of
the reach of children.