Publicité
ASSEMBLING SIDE
MOUNTING BRACKETS
STEP 4
NOTE: For Face Frame
applications, the product
member bracket and the side
only the product member bracket and the side
mounting bracket are needed.
The mending plate is only needed
for Frameless applications
(See Figure 4.1).
Please refer to Figure 4.2 and
ning. Fasten the brackets according to table
the table in Figure 4.3 for proper
order placement of the M5 Nylock
nuts, M5 x 14mm screws, and M5
washers.
MEMBER
MEMBER
!
e-mounting bracket is flush with the front of the face
there will be resistance. (SEE FIGURE 4A)
ATTACHING THE SLIDES
TO THE CABINET
oor of the cabinet.
STEP 5
6 x 5/8" flat head screws provided. (SEE FIGURE 5A)
Locate the bottom of the side
mounting bracket and place at
15-3/4" (50 qt. version) or
10-11/16" (35 qt. version) from
bottom of the face frame
(See Figure 5.1 & 5.2).
NOTE: Pre-drilling is
recommended when drilling into
the cabinet face frame to prevent
potential wood damages.
STEP 6
While supporting the front of the
side mounting bracket, engage
the back of the slide with the rear
strap assembly by sliding it into the
outer socket of the assembly. The
product member should be pushed
into the rear strap assembly until
the front of each product member
and each side mounting bracket
is flush with the front of the face
frame. This is a press fit and there
will be resistance (See Fig 6).
Continue to support the front of
the slide.
NOTE: Do not let it fall as it may
damage the rear strap assembly.
SIDE MOUNTING BRACKET
s not
FIGURE 4.3
TE
1-1/2" FACE FRAME
8
mm
1-5/8" FACE FRAME
1-3/4" FACE FRAME
FOR OVERLAY DOORS
THE FRONT EDGE OF THE SIDE
MOUNTING BRACKET SHOULD BE
FLUSH WITH THE FACE FRAME OF
THE CABINET.
INSTALLATION INSTRUCTIONS: REV-A-MOTION
FIGURE 4.1
PRODUCT
MEMBER
BRACKET
SIDE MOUNTING BRACKET
HOLE LOCATION
C
B
A
FOR INSET DOORS
USING A SCAB BOARD (MINIMUM DEPTH 6"), FLUSH
THE CABINET SIDE WALLS WITH THE BACK OF THE
FACE FRAME. THE BACK OF YOUR FACE FRAME IS
NOW THE FRONT OF YOUR CABINET (SEE FIG 5.2).
FIGURE 5.1
SCAB BOARD
15-3/4" (50 QT.)
10-11/16" (35 QT.)
OVERLAY DOORS
FIGURE 6
®
KIT FOR TOP MOUNT WASTE CONTAINERS
FIGURE 4.2
PRODUCT MEMBER
HOLE LOCATION
C
B
A
!
FIGURE 5.2
15-3/4" (50 QT.)
10-11/16" (35 QT.)
INSET DOORS
3
Publicité
