Télécharger Imprimer la page

Segway Ninebot eKickScooter E2 Pro Manuel Du Produit page 6

Publicité

Les langues disponibles

Les langues disponibles

EN
3
Certifications
This product is certified to ANSI/CAN/UL2272 by SGS.
The battery complies with UN/DOT 38.3.
The battery complies with ANSI/CAN/UL2271.
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 5 mm between the radiator & your body. Cet équipement est
conforme aux limites d'exposition aux radiations de la IC définies pour un environnement non contrôlé. Cet équipement
doit être installé et utilisé à une distance minimale de 5 mm entre le radiateur et votre corps.
Industry Canada (IC) Compliance Statement for Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
CAN ICES-3 (B)/NMB-3(B).
Cet appareil contient des émetteurs/récepteurs exemptés de licence qui sont conformes aux RSS exemptés de licence
d'innovation, sciences et développement économique Canada.L'exploitation est autorisee aux deux conditions suivantes : 
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique 
subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement.
04

Publicité

loading

Ce manuel est également adapté pour:

051405u