TEFAL IS8300 Mode D'emploi page 19

1800133082-03 IS8300 _110x154 24/11/14 11:34 Page17
• Do not fill the boiler by the steam head holes or by the "Anti calc" draining outlet!
• Never immerse the steam head in water or any other liquid!
TROUBLESHOOTING
Problems
There is no steam.
The steam flow is low.
Water runs through the
holes of the steam
head.
The steamer takes a
long time to heat
and/or ejects white
particles.
The Press & Steam
accessory is crooked.
All manuals and user guides at all-guidesbox.com
Possible causes
The appliance has not
been switched on.
The hose has been
obstructed.
There is no water left in
the water tank.
The auto off system is
activated.
Your steamer has a build-
up of scale because it has
not been rinsed out
regularly.
The hose has been
obstructed.
There is condensation in
the hose.
Your steamer has a build-
up of scale because it has
not been descaled
regularly.
The Press & Steam
accessory has not been
installed properly.
The Press & Steam
accessory has not been
rolled properly.
Solutions
Check that the appliance has been plugged
in correctly. Press the On/Off button, the
indicator light located at the front of the
appliance will come on.
The appliance will begin producing steam
after approximately 30 seconds.
Check that the hose is not bent or twisted.
Switch off the appliance and fill the water
tank.
To reactivate the appliance: fill the water
tank and select the desired steam level.
See descaling process.
Check that the hose is not bent or twisted.
Never use the steamer in the horizontal
position. Hold the hose vertically
outstretched and wait for the condensed
water to return to the steamer.
See descaling process.
Install again the Press & Steam accessory
inside the integrated hanger.
Make sure it is well hooked, following the
instructions.
Make sure the Press & Steam accessory is
always dry then rolled with care when stored.
Do not crease it for storage.
EN
17