TEFAL IS8300 Mode D'emploi page 17

1800133082-03 IS8300 _110x154 24/11/14 11:34 Page15
• To use the lint pad, slowly brush the clothing with the grain or nap of the fabric.
• The pad can be cleaned by brushing it in the opposite direction. We recommend cleaning the
pad on an old cloth that can be discarded.
• We recommend to use the lint pad before steaming your clothes for perfect results.
4 • Crease attachment*
• Once the unit is unplugged and completely cooled down, remove the crease attachment by
sliding it off of the steam head.
5 • Glove*
AFTER USE
• Switch off the appliance by pressing the ON/OFF button.
• The light indicators on the control panel will go off, and you can then unplug the appliance.
(fig. 29)
• Hang the steam head in an upright position on the hook steam head.
Warning: never remove the Press & Steam accessory for storage before it has completely
dried. Always roll the Press & Steam vertical support for storage. Do not crease it.
• Empty and rinse the water tank each time before storage in order to flush out any scale
particles. (fig. 30)
• Loosely wind up the electrical cord and close with the Velcro™ strip, then hang it on the cord
hook on the pole. (fig. 32)
Warning: Never touch the steam head until it has cooled down completely.
1 • Transport
• Push back the 2 stability legs until locked in the appliance base.
• You can transport your appliance by lifting it up by the telescopic pole or by the appliance's
* depending on model
All manuals and user guides at all-guidesbox.com
• Remove the fabric brush. Completely slide the
• Push on the handle to open the crease
• Place the garment between the crease
• Release the handle.
• Starting at the top of the garment, move the crease
attachment in a downwards motion.
• The glove protects your free hand from the steam during use.
• To use the glove, put it on the hand you use to hold or pull the garment.
(fig. 24)
The glove should be only used with this garment steamer and not
for other purpose. Do not wash or iron the glove.
hook of the accessory into the slot located in the
lower part of the steam head.
attachment.
attachment and steam head.
(fig. 28)
(fig. 31)
(fig. 25)
EN
(fig. 26)
(fig. 27)
15