Taurus Alpatec AC 293 KT Manuel D'utilisation page 23

starts automatically and runs in the selected
operating mode.
3.CHANGE OF THE SET TIME
- In the running process of timer, if you are inten-
ded to change the existing timer, you can press
TIMER once, at the moment 88 Nixie tube will
flicker and display the remaining time, during
flicker pressing UP/DOWN can increase/decrea-
se time on the basis of the original time.
- -If you press TIMER again during flicker, the set
time will be cancelled, namely timer quits.
SWING
- Press this button to control the movement of the
louver.
COOLING MODE:
- Press mode to select cooling mode, cooling
mode indicator turns on.
- Press Up or Down to adjust temperature in a
range of 18~30ºC (64~86ºF).
- -When the up or down is pressed once, tempe-
rature will go up or down by 1ºC or 1ºF every
time.
- Press speed to select high, mid or low fan
speed.
FAN MODE:
- Press mode to select fan mode fan indicator
turns on.
- Press speed to select high, mid or low speeds.
- In that mode, press Speed for 5 seconds to run
the internal dry function, i.e. both upper and
lower fans work simultaneously. Press Speed
for another 5 seconds to cancel the internal dry
function.
- Temperature is not adjustable.
- Press Swing to turn off or turn on the up/down
swing function.
DEHUMIDIFYING MODE:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Temperature and speed are not adjustable.
- Press Swing to turn off or turn on the up/down
swing function.
SLEEPING MODE:
- After selecting Cool mode, press Sleep on re-
mote control (or press up and timer on operating
panel simultaneously) to enter Sleep mode,
both upper and lower fans are forcibly set at
LOW speed.
- In approximate 7h the air conditioner turns off
automatically. If SLEEP is to be cancelled, press
SLEEP again or conversion modes to cancel
the sleep function.
- Press SWING to turn off or turn on the swing
function.
- Sleeping mode is invalid under dehumidifying
and fan mode. Under water full, machine stan-
dby and mode conversion, sleeping mode will
be cancelled
COMPRESSOR PROTECTION:
- Three minutes later after power on / restart,
compressor starts to run.
WATER TANK FULL PROTECTION:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.
- Please discharge water in the machine accor-
ding to chapter "water drainage".
WATER DRAINAGE:
- When the inner water tank is full, its indicator
will flash on the screen.
- The appliance enters into standby mode.
- Pull out the plug to drain out water, power off
the machine and restart it , the machine will
runs normally .
- This model have self evaporative function,
under cooling mode, please do not use continue
drainage to get better cooling effect.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
ONCE THE APPLIANCE HAS BEEN USED:
- Stop the appliance by pressing button (A) on/off
- Unplug the appliance from the mains.
- Unplug the appliance from the mains and allow
it to cool down before starting any cleaning
operation.
- Clean the electrical assembly and the mains
plug with a damp cloth and dry them after-
wards. NEVER SUBMIT THEM IN WATER OR
ANY OTHER LIQUID.
CLEANING
- Wipe the appliance with a damp cloth impreg-
nated with a few drops of detergent. Do not use