Haier XS 6B0S3FSB Manuel D'utilisation page 193

WARNING:
With this option selected, you must
not in any way prevent the door from
opening or force it to close so as not
to damage the mechanism. Leave the
space in front of the door free and
before closing it, wait for the opening
device to reactivate.
CHILD LOCK
CHILD LOCK ACTIVATION
The dishwasher is equipped with an
electronic child lock.
disables commands, thereby preventing
unwanted or accidental changes from being
made.
Child protection can
deactivated as follows:
1. Turn on the dishwasher on by pressing
and holding the "ON/OFF"
2. Press the "CHILD LOCK"
for about 5 seconds.
3. The display will show "CHILD LOCK
ON" and a short beep will be heard.
4. Only the "ON/OFF"
remain active.
5. Each time you press the disabled keys,
the display will show "LOCK".
CHILD LOCK DEACTIVATION
1. Press the "CHILD LOCK"
for about 5 seconds.
2. "LOCK OFF" will appear on the display
and a short beep will be heard.
Turning off the machine with the "ON/
OFF" button, will activate the child
protection the next time the machine is
switched on.
Child protection
be activated or
button.
button
button will
button
138
"NO SALT" warning light
When the "SALT" message appears on the
display or, where present, the relative light
comes on , fill the tank (see chapter
"ADDING THE SALT").
If the softener level is set to 0, this will
never happen (see chapter on setting
the softener).
"NO RINSE AID" warning light
When the "RINSE AID" message appears
on the display or, where present, the
relative light comes on
chapter "ADDING RINSE AID").
If the RINSE AID level is set to 0, this
will never happen.
DELAY START button
Delay start selection
This button allows you to programme the
start of the wash cycle, with a delay
between 0:30 and 24 hours.
To set the delayed start proceed as follows.
1. Switch the dishwasher on by holding
down the "ON/OFF"
3 sec.
2. Select the washing programme.
3. Press the "DELAY START"
("0:30" will appear on the display).
4. Press the button again to increase the
delay (each time it is pressed, the delay
is increased by 30 minutes, up to a
delay of 4 hours. Each time the button
is pressed it will increase by 1 hour up
to a maximum of 24:00. Pressing the
button again after a delay of 24:00 will
return to 0:00 (delayed start disabled).
, fill the tank (see
button for about
button