Geberit 185 Manuel D'utilisation page 18

EN
Rectifying malfunctions
Malfunction
Water jet too
weak
No flush
actuation
Water runs
continuously
Unwanted flow of
water, either too
soon or delayed
Water drips from
the tap housing
Red LED flashes
6 times after a
flush actuation
Red LED flashes
permanently, no
flush actuation
Skilled persons will find further information on troubleshooting on the website of the respective
Geberit sales company.
18
Cause
Tap aerator dirty
Dirty basket filter
Pipe pressure too low
Pipe pressure too low
Network failure
Batteries dead or rechargeable
battery for generator operation
empty
Technical fault
Technical fault
IR window is dirty or wet
IR window scratched
Detection distance of the IR sensor
not set correctly
Technical fault
Battery almost dead or
rechargeable battery for generator
operation almost empty
Battery dead or rechargeable
battery for generator operation
empty
Rectification
▶ Clean the tap aerator. → See
"Cleaning the tap aerator",
page 19.
▶ Clean the basket filter. → See
"Cleaning the basket filter
(mains/battery)", page 20.
▶ Contact a skilled person.
▶ Contact a skilled person.
▶ Check the power supply.
▶ Contact a skilled person.
▶ Contact a skilled person.
▶ Shut off water supply and
contact a skilled person.
▶ Clean or dry the IR window.
▶ Contact a skilled person.
▶ Contact a skilled person.
▶ Shut off water supply and
contact a skilled person.
▶ Contact a skilled person.
▶ Contact a skilled person.
36028804643541899 © 02-2022
970.656.00.0(00)