Publicité
Les langues disponibles
Les langues disponibles
4.1 Assembly the pressure gauge
5 OPERATION
For the pump's good working, you must prime the pump prefilter until water dips into the suction tuble Fig 12
The operation of this filter is based on the filtration capacity of the silica sand which is inside. The water in the pool is
driven by the filter pump and forced to pass through the silica sand. The sand acts as a filtering element which retains the
impurities in the water. The environment, trees, pollen, insects and frequency of bathing, as well as other factors,
determine the dirtiness of the water in the pool. Depending on the dirtiness, the silica sand in the filter should be cleaned
with greater or less frequency (see section 5.3).
To maintain the pool water in good condition, use the chemical products recommended by the manufacturer (chlorine,
alga protection, flocculant etc.).,
THE CHEMICAL PRODUCT SHOULD NEVER BE PLACED IN THE BASKET OR THROUGH THE FILTER, THIS
WOULD DETERIORATE THE MATERIALS OF THE UNIT AND LIMIT ITS EFFICACY.
5.1 Priming the filter
The filter must be correctly primed at all times. If the filter is not primed this means that an air chamber has been created
inside which causes defective circulation of water. This fact prevents proper filtration of the water by the silica sand and is
detrimental to the motor.
9
Publicité
