Publicité
Les langues disponibles
Les langues disponibles
SAMOA MONOBLOCK INSTRUCTIONS
SAMOA FILTER INSTRUCTIONS
• All electrical installations should comply with the following standard;
that refers "to the construction of electrical installations, both in indoor and outdoor swimming pools", or the equivalent
standard in force in each region or country.
• All filtering should follow the 2006/95/CE installation standard that stipulates that all electrical apparatus located at
less than 3.5 m. from the pool and freely accessible, should be supplied by a very low voltage of 12 V. All apparatus
supplied with 220 V should be located at least 3.5 m. from the swimming pool edge. Ask the manufacturer for
permission to make any modifications in one or more elements of the filtering system.
• The electrical installation should be performed by professional staff qualified in electrical installations.
• The height of the sand should not exceed 2/3 of the height of the tank.
• The apparatus must not be on while the pool is being used.
• Do not operate the apparatus unless it is properly primed.
• NEVER touch the filter when it is operating if you are wet or have wet hands.
• When handling the filter or valve, DISCONNECT the power supply.
• Make sure that the ground is dry before touching the electrical equipment.
• Do not install the filter where it could become wet, as it may cause electrocution.
• Do not allow children or adults to lean against or sit on the apparatus.
• If the supply flex of the apparatus is damaged, it should be replaced. Read the instructions carefully to replace it.
If in doubt, contact the technical service.
1 PACKAGING COMPONENTS
The filter which you have just purchased is a device which is especially planned and designed for elevated pools. As a
result of its innovative design and high level of functionality, it provides you with the different components required to filter
water: prefiler,filter, pump and selector valve in a single unit. The main components of this filter are as follows:
Model
SAMOA MONOBLOCK 300
SAMOA MONOBLOCK 301
SAMOA MONOBLOCK 400
SAMOA MONOBLOCK 300
SAMOA MONOBLOCK 301
SAMOA MONOBLOCK 400
SAMOA MONOBLOCK 300
SAMOA MONOBLOCK 301
SAMOA MONOBLOCK 400
SAFETY INSTRUCTIONS. READ CAREFULLY
2006/95/CE
EN 60-335-2-41
Fig.
No.
1
2
1 TOP selector valve
1
6
1 Plastic Base
1
8
1 Hose connection of Ø38 x 750mm
1
3
1 neck clamp
1 sand locator
1
9
2 hose clamps
1
1
1 Pressure gauge set
1
5
1 collector
1
4
Filter Ø300
1
4
Filter Ø400
1
7
Pump 125 W
1
7
Pump 180 W
1
7
Pump 230 W
Description
2
ENGLISH
Publicité
