Publicité
Les langues disponibles
Les langues disponibles
2019 - 2020 F150 CrewCab XLT and SuperCab XLT
Remove the bolt and separate the seatbelt.
Torque: 44 lb.in. (5 Nm)
All Vehicles
Remove the retainer and the outboard
cushion side shield.
NOTE: If the tether clip is damaged during
removal, a new clip must be installed prior
to installation of the panel.
NOTE: During installation make sure to
install the clip by the scuff plate trim panel
first and work upward on the trim panel to
connect the other clips.
Remove the C-pillar trim panel.
1. Release the clips.
2. Release the tether clip and remove
the C-pillar trim panel.
Page 9 of 20
Contact KICKER
Technical Support at 405-533-7499, or oesupport@kicker.com.
®
Route wire harness down the LH side of
vehicle from ACM to C-Pillar area.
NOTE: Use supplied wire ties where
needed.
© Copyright Ford 2019 FoMoCo
Publicité
