Publicité
Les langues disponibles
Les langues disponibles
2019 - 2020 F150 CrewCab XLT and SuperCab XLT
Kicker® Subwoofer Installation
NOTE: Release lever shown with seat in down
position for clarity.
Fold down the rear seat.
1. Pull release lever
2. Rotate seat back forward.
NOTE: Some vehicles may have provisions
for subwoofer brackets from the factory and
therefore do not require this step.
NOTE: It is only necessary to make a cut
indicated by the dotted line to allow the
vertical portion of the brackets to protrude
through carpeting.
NOTE: Cuts must extend to the rear edge of
carpet.
Make measurements from the center of the
seatbelt stud and from the back wall. Cut
the carpet and insulation to allow it to lie
over brackets once installed.
Page 10 of 20
Contact KICKER
2
1
Technical Support at 405-533-7499, or oesupport@kicker.com.
®
115mm
Razor Knife
Front of
Vehicle
327mm
Install bracket. Torque: 46 lb.in. (5.2Nm)
Lower the subwoofer into position aligning
the plastic fastener with bracket hole.
Install bolt. Torque: 46 lb. in. (5.2 Nm)
© Copyright Ford 2019 FoMoCo
115mm
338mm
X2
Publicité
