Publicité
Les langues disponibles
Les langues disponibles
2019 - 2020 F150 CrewCab XLT and SuperCab XLT
Battery Disconnect
NOTE: When the battery is disconnected
and connected, some abnormal drive
symptoms may occur while the vehicle
relearns its adaptive strategy. The vehicle
may need to be driven to allow the PCM to
relearn the adaptive strategy values.
NOTICE: Be careful not to damage the
battery monitoring sensor when removing
the terminal from the battery post. Do not
pry on the terminals or component damage
may occur.
NOTE: The following step is to interrupt
power to the vehicle's electrical system. It is
not necessary to disconnect the positive
battery cable terminal.
Loosen, but do not remove the nut. Position
the negative battery cable aside.
Torque: 55 lb.in (6.2 Nm)
Power Wire Installation
NOTE: Removal steps in this procedure
may contain installation details.
Release the retainers and remove the battery
junction box cover.
Page 3 of 20
Contact KICKER
Technical Support at 405-533-7499, or oesupport@kicker.com.
®
Lift the cowl trim panel to release the
underside pin-type retainers.
LH Side
RH Side
Remove the Power Distribution Box
terminal fastener indicated.
Connect the power harness to the terminal
indicated.
Torque: 93 lb.in (10.5 Nm)
© Copyright Ford 2019 FoMoCo
Publicité
