Nederman FilterBox Manuel D'instruction page 20

EN FilterBox
NOTE! Use appropriate bolts and plugs for the surface. The bolts must each stand a
stress of at least 2100 N.
Attach fan package
3.2
See figure 6. Connect the cable from the motor to the fan.
NOTE! On 3-phase fans, make sure the fan rotates in the direction of the arrow, see
figure 7. If the fan rotates in the wrong direction, switch the connection for two of the
cables.
Attach collector bin
3.3
See figure 11. Nederman recommends the use of plastic bags in the collector
bin for better dust disposal. When using a plastic bag, a pressure equalization
tube must be connected to the collector bin, see figure 11, items 4 and 5.
NOTE! If no bag is used, tie a knot to seal the cable, see figure 12, item 4.
3.4 Connect Arm
See:
User manual: Original Series 535.
1.
Mounting instruction: Extraction Arm Original Light Package.
2.
3.5 Connect compressed air
See figure 8.
CAUTION!
Use clean air according to DIN ISO 8573-1, class 5/5/4 (250 l/min, 7 Bar).
Automatic filter cleaning
3.6
Automatic filter cleaning occurs when the pressure drop across the filter
reaches a standard preset value. FilterBox
filter cleaning process begins.
NOTE! If the preset value is reached during use, the product goes into idle mode and
starts filter cleaning.
To setup automatic filter cleaning [ON/OFF], see figure 16.
Filter cleaning with preset time interval
3.7
For certain applications, it may be preferable to use filter cleaning with a
preset time interval. Filter cleaning starts when the unit is in idle mode and
not being used, see figure 17.
3.8 Connect tools to control panel
Compressed air and electrical tools can be connected to the outlets J (1-phase)
and K, see figure 2. To connect welding clamp, see figure 9.
By default, the FilterBox fan automatically starts when a tool connected to one
of these outlets is used. But, this feature can be disabled in item 5 'A/M fan
20
goes into idle mode before t
he