LENCO Classic Phono TT-10BN Mode D'emploi page 8

If the AUTO/ STOP selector (8) is ON, the record will stop rotating at the end of the last song.
11.
WARNING: if the record stops rotating before the end of the last song (not all records are the
same), then put the AUTO/ STOP selector (8) on OFF.
12. Use the lever again to lift the tone arm (the deck will start to rotate again), move it back to the clip and
lower into the cradle. The deck will stop.
13. Secure the tine arm using the clip and refit the stylus cover after use and always before moving the
turntable.
14. To turn off the turntable at any time, lift the tone arm on the record and turn the volume knob fully
anticlockwise.
Note
Some records have larger center hole and it may be necessary to fit the center hole adaptor to the turntable
shaft before placing the record on the turntable. Always refit the stylus cover and secure the turntable arm
using the clip before moving the turntable.
Using with auxiliary device
1. Auxiliary analogue audio equipment can be connected and amplified via the turntable
2. Connect the auxiliary equipment using a 3.5mm jack cable (cable not included) into the LINE IN jack.
3. Press the play button on the auxiliary equipment and use the track controls as usual on the auxiliary
device
4. The volume can be adjusted using the volume knob on the turntable or the controls on the connected
auxiliary device.
5. To turn off the unit at the anytime turn the volume knob fully anticlockwise
Using headphones (not included)
A stereo headphone jack has been provided so that the turntable can be used without disturbing others. Plug
in the headphones at the point marked headphone near the volume knob and adjust the listening volume to
your chosen level. Excessive sound pressure from earphones and headphones can cause hearing loss. The
turntable speakers will not operate when earphones are fitted.
Connecting the turntable to external speaker
Connecting the turntable to external speakers (via a suitable amplifier)
Use a twin phono to twin phono lead (not included) to connect the RCA output jacks to the Audio in of the
amplifier. Ensure red plugs are inserted into the red sockets and white into white.
8