Télécharger Imprimer la page

Beko B3RDNE66HXP Manuel D'utilisateur page 11

Publicité

Les langues disponibles

Les langues disponibles

4
Installation
4.1 The right place for installation
Your product requires adequate air circulation to
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
clearance between the product and the ceiling,
rear wall and the side walls.
If the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and
the side walls. Check if the rear wall clearance
protection component is present at its location (if
provided with the product). If the component is
not available, or if it is lost or fallen, position the
product so that at least 5 cm clearance shall be
left between the rear surface of the product and
the wall of the room. The clearance at the rear is
important for efficient operation of the product.
A
WARNING:
sockets in power connection.
B
WARNING:
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
B
WARNING:
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
WARNING:
A
narrow for the product to pass, remove
the door and turn the product sideways; if
this does not work, contact the authorized
service.
vibration.
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
keep in damp environments.
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.
Refrigerator / User Guide
Do not use extension or multi
The manufacturer assumes
The product's power cable
: If the door span is too
4.2 Attaching the plastic wedges
*May not be available in all models
Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the screws on
the product and use the screws provided with the
wedges.
2. Attach 2 plastic wedges on the ventilation cover as
shown in the figure.
11 / 29 EN

Publicité

loading