Regular Maintenance - Nacecare TT 1117/100 Mode D'emploi

!
The TT Range has been designed with ease of use in mind, this included easy stripping-down and cleaning.
A
Fig 20
Fig 22
Remove the filter fitted into the separator and flush with clean water (Fig 22)(Fig 23).
Placed into the top tank is grey filter basket, clean and flush with clean water (fig 24) (Fig 25).
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
Fig 21
Fig 23
The Bottom (Clean Water) tank is attached to the chassis and should only
be removed by a competent service engineer (Fig 26).
Clean by flushing with clean water if required.
Excess water can be drained using the clear dump hose fitted to the rear
of the machine.
Located under the left hand side is a clean water filter, ensure the clean
Fig 26
water tap is turned off before removing this filter (Fig 27).
Clean and flush with clean water if required.

Regular Maintenance

After use, empty waste-water tank using
emptying hose
water (Fig 19).
Fig 19
Remove the two hoses to disconnect the separator from the
machine (Fig 20).
Lift off the separator. The separator has a sealing-rubber
which should be examined at every clean-down (Fig 21).
Rinse using clean water.
Fig 24
12
!
A
and flush-out with clean
Fig 25
Fig 27