Panasonic TY-ST65P20 Manuel D'installation page 11

Assembly Procedure
1. Assemble the Pedestal
Make sure you do not scratch the surface of the stand
base.
Attach the stand pole installation screws
to the aligned stand base
poles) using the provided Allen wrench
the diagram.
(Tightening torque: 1.5 to 1.8 N•m)
2. Install the Plasma Display
Place the assembled pedestal with the rear side (side
with the model nameplate attached) facing towards
yourself, align the mounting hole ( ) of the plasma
display with the stand poles, insert the stand poles
into the plasma display until they stop, and attach the
unit installation screws
tighten the screws securely.
(Tightening torque: 1.5 to 1.8 N•m)
Use a Phillips head screwdriver to remove the caps
at the left and right top on the rear side of the plasma
display, and attach the overturn-prevention hooks
hooks) to the plasma display using the hook securing
screws (2 screws).
(Keep the caps you have removed carefully.)
(Tightening torque: 2.0 to 2.5 N•m)
3. Installation of Plasma Display
For details on wiring connections, see the instruction manual of the plasma display.
After installing the plasma display, lay the various cords and cables at the rear of the display.
Do not bunch the power cord together with other cords and cables.
(6 screws)
with the stand poles (2
as shown in
(4 screws) temporary. Then
(2
Allen wrench
Stand pole
Stand base
* The shape of the plasma display will differ
depending on the model. The following illustration
is an example of an applicable model.
Unit installation
Rear of Plasma Display
screw
Unit installation screw
Hook
フック
キャップ
Cap
Hook securing screw
フック固定用ねじ
Stand pole
installation screw
Stand pole
Model Nameplate
Phillips head
プラスドライバー
screwdriver
Hook
フック
Hook securing
フック
screw 固定用ねじ
11