Télécharger Imprimer la page

Stihl BGA 60 Notice D'emploi page 18

Masquer les pouces Voir aussi pour BGA 60:

Publicité

Les langues disponibles

Les langues disponibles

English
■ Do not modify or attempt to repair the blower or the battery
pack. Follow the instructions for use and care.
10 Before Starting Work
10.1 Preparing the Blower for Operation
Before starting work:
► Fully charge the battery, @ 11.
► Mount the nozzle, @ 13.1.
► Check the controls for proper function and condition,
@ 16.
11 Charging the Battery
11.1 Setting up the Charger
WARNING
Read and follow the battery and charger safety precautions
and instructions in this manual, @ 6 and @ 7. To reduce
the risk of short circuit, which could lead to electric shock,
fire and explosion, make sure the charger and its
components are dry and not damaged; operate the charger
indoors at an appropriate ambient temperature, @ 7.
WARNING
A typical household electrical circuit is between 15 and
20 amps. A single STIHL AL 101 charger draws
approximately 1.3 amps. To reduce the risk of fire from
overloading an electrical circuit:
► Ensure the electrical system is rated to withstand the
expected electrical draw before charging your battery.
► Charge multiple batteries one at a time or on separate
circuits, unless you know your circuit can handle the total
expected draw from multiple chargers.
16
WARNING
Since the battery and charger heat up during the charging
process, do not operate the charger on a combustible
surface or in a location where combustible gases, liquids,
vapors, dusts or other materials and substances are
present, @ 7.
To set up the charger:
2
1
► Insert the plug (3) into a properly installed electrical
outlet (4) matching the voltage and electrical frequency
stated on the charger's rating plate.
The charger runs a self-test immediately after it is plugged
in. The charger LED (1) will glow green for about 1 second,
then it will glow red briefly before going out. Once the LED
goes out, the self-test is complete and the charger is ready
to charge the battery.
► Position the power supply cord (2) so that it will not be
stepped on, tripped over, come in contact with sharp
objects or moving parts or otherwise be subjected to
damage or stress.
11.2 Charging
WARNING
STIHL batteries contain safety features and devices which,
if damaged, may allow the battery to generate heat, rupture,
leak, ignite or explode. Never charge a malfunctioning,
damaged, cracked, leaking or deformed battery or use a
charger that has been damaged. For indoor use only. Keep
10 Before Starting Work
4
3
2
0458-008-8201-A

Publicité

loading