Clean the wetted pad (Picture 2)
Cut off the power supply, unscrew the screw on the top edge of air filter screen, take down the air filter
screen, unlock the wetted pad and its support, and take out them, then draw the wetted pad from support.
Clean the wetted pad with soft dry cloth. Finally, reinstall to the appliance and lock the support with wetted
pad. Then screw the screw on the top edge of the air filter screen.
Attention: the wetted pad must be installed horizontally, in order to aviod leaking.
Postseason storage:
When the air coller is out of season or not used for long time, corresponding maintenance
measures should be taken.
Pull out the water wedge to drain.
Turn off the air coller and unplug.
Wash the filter screen and reassemble it.
Cover the air coller with a plastic bag and place it at a dry place.
7. IN THE EVENT OF A BREAKDOWN
Despite the care we take during production, a breakdown can never be totally ruled out. Before contacting your
retailer's after-sales department, please check that:
The appliance is properly plugged in
There is not a power cut in progress
The breakdown is not one of those described in the table at the end of this manual
IMPORTANT: if the power cable supplied is damaged, it must be replaced by the manufacturer, a service
centre approved by the brand or the retailer. In all events, it must be replaced by qualified personnel in
order to avoid any risk of injury.
Picture 1
Picture 2
27