Publicité
Les langues disponibles
Les langues disponibles
Air Conditioner Features
WARNING:
To reduce the risk of re, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this
appliance.
CAUTION: Please always wait 3 minutes when turning unit off then on again, and when changing from cool to fan and back to cool. This
prevents compressor from overheating and possible circuit breaker tripping.
To begin operating the air conditioner, follow these steps:
1. Set the thermostat to the highest number (coldest or cooler setting).
2. Set the selector control to the highest COOL setting.
3.
Adjust the louver for comfortable air ow (see Air Directional Louvers).
4.
Once the room has cooled, adjust the thermostat to the setting you nd most comfortable.
5.
Make sure that the air ow inside and outside are not obstructed by anything.
AIR DIRECTIONAL LOUVERS
The louvers will allow you to direct the air ow left or right throughout the room as needed.
Move the levers from side to side until the desired left/right direction is obtained.
Levers
Air Direction
The louvers will allow you to direct the air ow up or down (on some models) and left or right throughout the room as needed. Pivot
horizontal louvers until the desired up/down direction is obtained. Move the lever(s) from side to side until the desired left/right direction is
obtained.
MECHANICAL CONTROL OPERATING INSTRUCTIONS
NOTE: The controls featured in this manual are representative
of many available models. Your model may offer slightly different
features.
Cool Mode
The desired cool setting is selected by rotating the knob to the right to the appropriate location.
HI COOL
has maximum cooling effect and air ow.
LO COOL
has minimum cooling effect and air ow.
MED COOL
has the intermediate cooling effect and air ow (on some models).
OFF will completely shut off the unit.
NOTE: If your unit is equipped with a vent handle, keep it closed
for maximum ef ciency.
Levers
Air Direction
16
Lever
Levers
Air Direction (4-way)
Publicité
