Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Robot suddenly stops
cleaning and indicator
1
stays in blue
Power on robot, its
indicator is in blue
2
Robot does not change
direction when it comes
3
up against obstacle
During charging, LED
indicator flashes in red
and robot beeps
4
LED indicator flashes in
5
red
Blue LED flashes once,
6
Red LED flashes once.
Blue LED flashes once,
7
Red LED flashes twice.
Blue LED flashes once,
8
Red LED flashes triple.
Note: if all solutions given above don't work for you, please take actions below:
1) Re-set the robot by toggling the power switch on bottom side of the robot.
2) If re-set action doesn't work, please send the robot to seller for repairing.
Possible Cause
1. Robot was picked up
1. Cliff sensor fault
1. Bumper sensor fault
1. Robot switch might not
powered on
1. Battery low
1. Side brush get stuck
1. Robot bumper is not
flexible enough
1. Robot wheel get stuck 1. Check wheels and take out the foreign object
Solution
1. Re-place the robot on the floor and re-start the robot
1. Clean cliff sensor
2. If solutions given above doesn't work, send it to the
seller for repairing
1.Check the sensor to see if it is covered by any object
1. Switch on the robot
1. Fully charge the battery
1. Put robot on flat surface and clean side brush
1. Loosen half circle of bumper bottom screw
13
Publicité
