SANNOVER ANITA 10 KW Manuel Utilisateur page 47

5.5 Oxygen supply for combustion
During the combustion process, the stove must draw air from the room, therefore, High and Low Air Inlets
must be installed in it.
6 General steps and instructions for use
6.1 General notes
The stove must be installed correctly.
It is necessary to use high-quality pellets (the standard of the pellets is DIN 51731, and OENORM M 7135,
DIN +, or similar). Pellet diameter: 6 mm, length ≦25 mm.
During the initial phase of use, you should try different brands of pellets, then choose a brand that has a high
calorific value but a low ash content and a low risk of slag. Pellets with a high ash content increase the
frequency of cleaning, and pellets too rich in water block the worm screw, which leads to the dysfunction of
the stove.
The product is not suitable for burning wood and does not work as an incinerator!
It is strictly forbidden to put waste, garbage and various plastics in the stove to burn them. The warranty
conditions and articles of this document will not be valid if one of the aforementioned situations occurs.
If the stove is used in accordance with the manual, no overheating is possible.
Use that is not in accordance with the instructions may damage the electrical components (such as fans,
worm screw motor, control unit, etc.) and reduce their service life.
6.2 Control unit
The stove is fitted with a microprocessor and control components.
All functions and adjustments can be made using the control panel mounted on the top of the stove.
Fault resets must be approved by professionals.
Incorrect use or adjustments may damage the stove and render the conditions and articles of the warranty
null and void.
Ignition solution in case of failure of self-ignition:
In the event of failure of self-ignition, remove all the pellets from the Crucible, replace it correctly and
restart the stove. Otherwise, too large a quantity of pellets in the Crucible during the ignition phase
can cause a detonation!
Filling with wood pellets
Warning! Risk of fire!
Keep the plastic bags of the pellets away from the stove during the pellet supply.
The pellets must not protrude from the lid of the hopper; the excess pellets must be
removed.
To prevent the fire from going out, ensure to maintain the pellets at an adequate filling
level in the hopper.
You can fill the pellets if you see the screw at the bottom of the hopper.
The storage height of the pellets must be checked regularly.
With the exception of the fuel supply process, the lid of the hopper must be closed in
all cases.
Warning! To avoid high-temperature burns, always wear protective gloves to open
the hopper lid.
EN