Oase Aquarius Eco Expert 7300 Notice D'emploi page 10

- English -
Cleaning the unit
1. Remove the screws for fastening the filter basket
and remove the filter basket.
2. Clean all parts.
• Use a soft brush.
• Rinse parts in clean water.
3. Reassemble the unit in the reverse order.
Replacing the impeller unit
NOTE
The impeller unit is guided in the motor block by a bearing. This bearing is a wear part and should be changed at the
same time as the impeller unit.
• Changing the bearing requires specialist knowledge and tools. Have the bearing changed by your OASE specialist
dealer or send the pump to OASE.
NOTE
The impeller unit contains strong magnets that attract magnetic particles (e.g. iron filings)
• All particles must be removed from the impeller unit before reassembly. Any remaining particles can cause
irreparable damage to the impeller unit and motor block.
• The pipes/hoses at the inlet and outlet are removed.
1. Remove the screws for fastening
the filter basket and remove the filter
basket
2. Remove the screws for fastening the
stand and remove the stand
3. Remove the four screws and take off
the pump casing
4. Pull out the impeller unit and replace if
necessary.
• Use a wide-blade screwdriver to
carefully lever out the impeller unit
if necessary.
5. Reassemble the unit in the reverse
order.
10