Husqvarna LC 551SP Manuel D'utilisation page 17

2. Hit the air filter against a hard surface or blow
compressed air through the air filter from the clean
side of the air filter.
CAUTION:
remove dirt as this pushes the dirt into
the air filter.
3. Clean the air filter holder (D) and the air filter cover
with a moist cloth.
CAUTION:
goes into the air duct (E).
4. Install the air filter. Make sure that the air filter fully
seals against the air filter holder.
5. Install the air filter cover with the bottom tabs first.
To examine the spark plug
CAUTION:
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
Engine
Brand
1906 - 005 - 21.08.2023
Do not use a brush to
Make sure that no dirt
Always use the
Transportation, storage and disposal
Technical data
LC 551SP
Kawasaki
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 17 . (Fig. 58)
• Replace the spark plug if it is necessary.
To examine the fuel system
• Examine the fuel tank cap and the seal for the fuel
tank cap to make sure that there are no damages.
• Examine the fuel hose to make sure that there are
no leaks. If the fuel hose is damaged, let a service
agent replace it.
To adjust the speed control and throttle
control
The speed control adjusts the drive speed. The throttle
control adjusts the engine speed.
CAUTION:
control when the engine is on.
1. To adjust the drive speed, turn the adjuster screw
(A) to adjust the length of the cable sheath. Make the
cable sheath shorter to increase the drive speed.
2. If the choke position or stop position cannot be
engaged, adjust the engine speed. Turn the adjuster
screw (B). (Fig. 59)
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
LC 551VBP
Kawasaki
Technical data
Do not adjust the speed
LC 551VQ
Husqvarna
17