Publicité
Les langues disponibles
Les langues disponibles
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this blower. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
ASSEMBLY
INSTALLING THE BLOWER TUBE
See Figure 2.
„ With the slot facing down, align the tab on the blower
housing with the slot in the blower tube.
„ Slide the blower tube over the outlet on the blower hous-
ing.
„ Press in on the tab on the blower housing outlet.
„ Push tube on the blower housing outlet until tab locks
into place through the slot in the blower tube.
NOTICE:
When correctly assembled, the tube is difficult to
separate. If it can easily be twisted apart, the tube is not
locked. Continue twisting together until the tube snaps
into the locked position. If the tube is not in the locked
position, it can separate during blower operation.
„ To remove the blower tube, push tab in and slide tube off.
OPERATION
Verify that all guards and tubes are in place prior to use.
If the blower is dropped, stop blower and verify that
no damage has occurred. If any guard, part, or tube is
damaged or missing, do not use blower until it has been
repaired or replaced by a qualified service center. Use of
blower with damaged or missing guards, parts, or tubes
can result in serious personal injury or further damage
to the blower.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
6 — English
WARNING:
Publicité
