LG DL X860 E Serie Manuel D'utilisation page 16

16 INSTALLATION
2
Remove the four hinge screws.
• While supporting the door, remove the four
hinge screws, two from each hinge. Set the
door aside face down on a protected
surface to prevent damage to the door or
the work surface.
3
Reverse the components on the cabinet.
1) Use a Phillips screwdriver to remove the
two screws and the latch mechanism
on the front panel of the cabinet.
2) Remove the latch hole cover
prying it up with a flat blade screwdriver,
being careful not to scratch the paint.
Install the latch hole cover on the
opposite side, where the latch mechanism
was removed. Install the latch mechanism
in the position from which you removed
the latch hole cover, using the two screws
removed in a previous step.
3) Remove the hinge cover
prying it up with a flat blade screwdriver,
being careful not to scratch the paint.
Rotate the hinge cover 180 degrees and
install it on the opposite side
the hinge was attached.
4) Reverse the hinge
f
bracket at the bottom of the cabinet.
Remove the two screws from the hinge
bracket at the bottom right and remove
the hinge bracket. Remove the lower of
the two screws behind the hinge bracket.
a
b
by gently
c
by gently
d
, where
e
and the hinge
Do NOT remove the upper screw behind
the hinge bracket. Set the parts aside.
CAUTION
• Do NOT remove any of the eight screws on the
face of the cabinet (marked below). Doing so
could result in damage to the dryer and the need
for a service call to repair the dryer.
5) Remove the three screws on the hinge at
the bottom left. Remove the hinge and
reinstall it on the right side. The top screw
will occupy the hole where you removed
the screw behind the hinge bracket in a
previous step.
6) Install the hinge bracket on the bottom
left side, first installing one screw behind
the hinge bracket.
ON THE DOOR :
1
Lift off the door cover.
• With the door laid inside facing up on a
protected surface, remove the twelve
screws on the inside of the door. Carefully
lift off the door cover with the help of a
small flat blade screwdriver inserted in the
upper corner.