Daily Operation; Remove Transport Packaging; Installation; Installation Location - La Sommeliere LS20 Mode D'emploi

Daily Operation

·Containers with flammable gases or liquids can leak at low temperatures. There is a risk of an explosion! Do not
store any containers with flammable materials such as spray cans, fire extinguisher refill cartridges etc in the wine
cooler.
·Do not operate any electrical appliances in the wine cooler (e.g. electric ice cream makers, mixers etc.).
·Before cleaning the appliance, always switch off the appliance and unplug it, or pull the house fuse or switch off
the circuit breaker .
·When unplugging always pull the plug from the mains socket, do not pull on the cable.
In case of malfunction
If a malfunction occurs on the appliance, please look first in the "Trouble shooting" section of these instructions. If
the information given there does not help, please do not perform any further repairs yourself.
·Under no circumstance should you attempt to repir the appliance yourself. Repairs carried out by inexperienced
persons may cause injury or serious malfunctioning. Contact your local Service Force Centre.

Remove transport packaging

The appliance and the interior fittings are protected for transport. Pull off the adhesive tape on the left
and right side of the door. You can remove any remnants of adhesive using white spirit. Remove all adhesive
tape and packing pieces from the interior of the Appliance.

Installation

Installation Location

The appliance should be set up in a well-ventilated, dry room. This product is for free standing only. Energy
use and efficient performance of the appliance is affected by the ambient temperature. The appliance should
therefore not be exposed to direct sunlight; not be installed next to radiators, cookers or other sources of heat;
only be installed at a location whose ambient temperature corresponds to the climate classification, for which the
appliance is designed. The climate classification can be found on the serial plate, which is located at the left on the
inside of the appliance. The appliance must be positioned so that the plug is accessible. If the wine cooler is
installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to prevent the
formation of condensation on the outside of the appliance.
14